Li-S rechargeable batteries are attractive for electric transportation because of their low cost, environmentally friendliness, and superior energy density. However, the Li-S system has yet to conquer the marketplace, owing to its drawbacks, namely, soluble polysulfide formation. To tackle this issue, we present here a strategy based on the use of a mesoporous chromium trimesate metal-organic framework (MOF) named MIL-100(Cr) as host material for sulfur impregnation. Electrodes containing sulfur impregnated within the pores of the MOF were found to show a marked increase in the capacity retention of Li-S cathodes. Complementary transmission electron microscopy and X-ray photoelectron spectroscopy measurements demonstrated the reversible capture and release of the polysulfides by the pores of MOF during cycling and evidenced a weak binding between the polysulphides and the oxygenated framework. Such an approach was generalized to other mesoporous oxide structures, such as mesoporous silica, for instance SBA-15, having the same positive effect as the MOF on the capacity retention of Li-S cells. Besides pore sizes, the surface activity of the mesoporous additives, as observed for the MOF, appears to also have a pronounced effect on enhancing the cycle performance. Increased knowledge about the interface between polysulfide species and oxide surfaces could lead to novel approaches in the design and fabrication of long cycle life S electrodes.
COBISS.SI-ID: 4816666
The formation of fractal silica networks from a colloidal initial state was followed in situ by ion conductivity measurements. The underlying effect is a high interfacial lithium ion conductivity arising when silica particles are brought into contact with Li salt-containing liquid electrolytes. The experimental results were modeled using Monte Carlo simulations and tested using confocal fluorescence laser microscopy and [xi]-potential measurements.
COBISS.SI-ID: 4783386
Based on the results of carefully designed experiments upgraded with appropriate theoretical modeling, we present clear evidence that the release curves from mesoporous materials are significantly affected by drug-matrix interactions. In experimental curves, these interactions are manifested as a non-convergence at long times and an inverse dependence of release kinetics onpore size. Neither of these phenomena is expected in non-interacting systems. Although both phenomena have, rather sporadically, been observed in previous research, they have not been explained in terms of a general and consistent theoretical model. The concept is demonstrated on a model drug indomethacin embedded into SBA-15 and MCM-41 porous silicates. The experimental release curves agree exceptionally well with theoretical predictions in the case of significant drug-wall attractions. The latter are described using a 2D Fokker-Planck equation. One could say that the interactions affect the relative cross-section of pores where the local flux has a non-vanishing axial component and in turn control the effective transferof drug into bulk solution. Finally, we identify the critical parameters determining the pore size dependence of release kinetics and construct a dynamic phase diagram of the various resulting transport regimes.
COBISS.SI-ID: 4727578